600Ma L293Dd Duplex Motor Conducteur Module Totaal Bridge Driver Voor Arduino Blauw White

The motor driver can control up to two DC motors at a constant current of 600mAh (1.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 5KHz. The motor and the external power supply interfaces use the XH2.54-2P socket instead of the traditional green screw terminal, easy to use, and you can avoid screwing. Note : However, when using the board at currents up to 0.6A, it may be necessary to improve thermal performance with a heat-sink. Features : - Driver Chip : L293DD - Power supply voltage : VM 30V max - Logic voltage : VCC 4.5-30V - Output current : Iout 0.6A(average) / 1.2A (peak) - CW/CCW/short brake/stop motor control modes - Built-in thermal shutdown circuit and low voltage detecting circuit - All pins broken out to 2.54mm spaced pins, and it can be pl Lees meer over de 600Ma L293Dd Duplex Motor Conducteur Module Totaal Bridge Driver Voor Arduino Blauw White van huismerk in de productgroep elektrisch en gereedschap