Esp8266 Open Source Remote Control E3P3D Wifi Module For 3D Printer Board Connect Ap Modeclient Station Mode

More info. please click here. Descriptions : 1. This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. 2. The ESP8266Wifi uses the ESP8266 module to provide web control to the board. Module communicates to the main board using UART (Tx/Rx). 3. Access point (AP mode) - This mode turns the ESP8266 wifi module into an access point and be able to accept client connections and provide IP address via DHCP. This mode allows your Phone, Tablet or PC to connect to the directly using wifi. This is useful during initial set up to connect the X5 mini to your network or when you want your machine to be on stand alone mode ( when showing off machine or in a trade show/classroom). Wifi module will automatically turn on this mode when it cannot find any known Wifi networks. 4. Client Station - This mode is selected when Lees meer over de Esp8266 Open Source Remote Control E3P3D Wifi Module For 3D Printer Board Connect Ap Modeclient Station Mode van huismerk in de productgroep elektronica